Lines Matching full:phy
74 /* BLE PHY data structure */
174 * bit in the NVIC just to be sure when we disable the PHY.
195 * Copies the data from the phy receive buffer into a mbuf chain.
289 /* If PHY is in idle state for whatever reason, disable it now */ in nrf_wait_disabled()
395 * @param tx_phy_mode phy mode for last TX (not used on nRF51)
600 /* Count PHY crc errors and valid packets */ in ble_phy_rx_end_isr()
682 ble_hdr->rxinfo.phy = BLE_PHY_1M; in ble_phy_rx_start_isr()
754 /* Disable PHY */ in ble_phy_rx_start_isr()
810 * ble phy init
812 * Initialize the PHY.
814 * @return int 0: success; PHY error code otherwise
832 /* Set phy channel to an invalid channel so first set channel works */ in ble_phy_init()
885 /* TIMER0 setup for PHY when using RTC */ in ble_phy_init()
909 /* Register phy statistics */ in ble_phy_init()
925 * Puts the phy into receive mode.
927 * @return int 0: success; BLE Phy error code otherwise
960 * Called to enable encryption at the PHY. Note that this state will persist
961 * in the PHY; in other words, if you call this function you have to call
962 * disable so that future PHY transmits/receives will not be encrypted.
1196 /* Set the PHY transition */ in ble_phy_tx()
1206 /* Set phy state to transmitting and count packet statistics */ in ble_phy_tx()
1221 * ble phy txpwr set
1255 * ble phy txpwr round
1278 * ble phy txpwr get
1282 * @return int The current PHY transmit power, in dBm
1291 * ble phy setchan
1302 * @return int 0: success; PHY error code otherwise
1360 * ble phy disable irq and ppi
1363 * wait for response timeout or a packet being received and the phy is to be
1365 * the phy.
1388 * ble phy disable
1390 * Disables the PHY. This should be called when an event is over. It stops
1410 * Return the phy state
1412 * @return int The current PHY state.
1446 * phy. For this chip, if encryption is enabled, the maximum payload is 27