Lines Matching full:temperature

12 	  Each thermal zone contains its own temperature, trip points,
25 	  zones discovery, temperature readings and events such as
130 	  Select this if you want to control temperature based on
161 	  Say 'Y' here if you want to use two point temperature regulation
236 	  directory to support temperature emulation. With emulation sysfs node,
237 	  user can manually input temperature and test the different trip
242 	  flooding this sysfs node with low temperature values.
250 	  memory-mapped reads to get the temperature.  Any HW/System that
251 	  allows temperature reading by a single memory-mapped reading, be it
267 	tristate "Temperature sensor driver for Freescale i.MX SoCs"
273 	  Support for Temperature Monitor (TEMPMON) found on Freescale i.MX SoCs.
279 	tristate "Temperature sensor driver for NXP i.MX SoCs with System Controller"
283 	  Support for Temperature Monitor (TEMPMON) found on NXP i.MX SoCs with
285 	  controller via MU (message unit) IPC to get temperature from thermal
290 	tristate "Temperature sensor driver for Freescale i.MX8MM SoC"
307 	  This includes temperature reading functionality.
310 	tristate "Temperature sensor driver for Maxim MAX77620 PMIC"
314 	  Support for die junction temperature warning alarm for Maxim
316 	  interrupts when PMIC die temperature cross the threshold of
359 	  Rockchip thermal driver provides support for Temperature sensor
362 	  CPUs when the Temperature crosses the passive trip point.
365 	tristate "Temperature sensor on Marvell Kirkwood SoCs"
374 	tristate "Temperature sensor on Marvell Dove SoCs"
407 	  This will report PMIC junction over-temperature for one thermal trip
462 	  This enabled a thermal sysfs driver for the temperature sensor
465 	  to this driver. This driver reports the temperature by reading ADC
466 	  channel and converts it to temperature based on lookup table.
479 	  thermal framework. The driver supports CPU thermal zone temperature
483 	tristate "Temperature sensor on Spreadtrum SoCs"
506 	  are used to obtain the temperature of the current node and set the
507 	  temperature range to trigger the interrupt. When the input temperature
508 	  is higher than the high temperature threshold or lower than the low
509 	  temperature threshold, the interrupt will occur.