Lines Matching full:be

41     description: boolean, regulator should never be disabled
49       This property is intended to only be used for regulators where
58     description: allow the regulator performance level to be configured
63       disabling ramp rate, it should be explicitly initialised to zero (regulator-ramp-delay
105       for the regulator at run-time.  Elements may be specified in any order.
131       hardware performs emergency shutdown. Zero can be passed to disable
132       protection and value '1' indicates that protection should be enabled but
133       limit setting can be omitted.
138       Zero can be passed to disable error detection and value '1' indicates
139       that detection should be enabled but limit setting can be omitted.
143       is assumed still to be functional but approaching limit where it gets
144       damaged. Recovery actions should be initiated. Zero can be passed to
146       be enabled but limit setting can be omitted.
150       hardware performs emergency shutdown. Zero can be passed to disable
151       protection and value '1' indicates that protection should be enabled but
152       limit setting can be omitted. Limit is given as microvolt offset from
158       Zero can be passed to disable error detection and value '1' indicates
159       that detection should be enabled but limit setting can be omitted. Limit
164       is assumed still to be functional but approaching limit where it gets
165       damaged. Recovery actions should be initiated. Zero can be passed to
167       be enabled but limit setting can be omitted. Limit is given as microvolt
172       hardware performs emergency shutdown. Zero can be passed to disable
173       protection and value '1' indicates that protection should be enabled but
174       limit setting can be omitted. Limit is given as microvolt offset from
180       Zero can be passed to disable error detection and value '1' indicates
181       that detection should be enabled but limit setting can be omitted. Limit
186       hardware is assumed still to be functional but approaching limit where
187       it gets damaged. Recovery actions should be initiated. Zero can be passed
189       be enabled but limit setting can be omitted. Limit is given as microvolt
198       be carried out in preparation for potential power loss.
202       hardware performs emergency shutdown. Zero can be passed to disable
203       protection and value '1' indicates that protection should be enabled but
204       limit setting can be omitted.
209       Zero can be passed to disable error detection and value '1' indicates
210       that detection should be enabled but limit setting can be omitted.
214       hardware is assumed still to be functional but approaching limit where it
215       gets damaged. Recovery actions should be initiated. Zero can be passed to
217       be enabled but limit setting can be omitted.
230       is 2-way - all coupled regulators should be linked with each other.
231       A regulator should not be coupled with its supplier.
244       that can be changed safely in a single step.
259         description: regulator should be on in suspend state.
263         description: regulator should be off in suspend state.
267         description: minimum voltage may be set in suspend state.
270         description: maximum voltage may be set in suspend state.
273         description: the default voltage which regulator would be set in
280           in suspend can be changed in runtime.